Toshiba e-STUDIO500P manual Count between 400,000 499,999 202 Is covering the exit

User attendance messages—paper jams and paper handling errors (2xx.xx)

Error	Sub	Description	Possible causes	Action
code	codes
202	.42	Exit sensor covered too	Page may be jammed in fuser exit or	• Make sure the redrive door
		long. Fuser page count	redrive area.		is complete closed.
		between 400,000 and		•	Check the fuser for any
		499,999.
					signs of wear or
					contamination. If any are
					found, replace the fuser
					assembly. See “Fuser
					assembly removal” on
					page 4-26.
				•	Turn media over to reduce
					+W curl.
				•	Check upper redrive
					diverter and diverter spring
					for any signs of damage, a
					loose spring, or binding
					parts. Repair the redrive as
					necessary.
				•	Check any installed output
					options(s) that may be
					installed for correct
					installation and alignment.
				•	The fuser exit sensor may
					not be functioning properly.
					Go to “Fuser exit sensor
					service check” on
					page 2-92.
202	.43	Page is covering narrow	• If page is not visible from front or rear	Check the fuser and area
		media sensor during	of the printer, a partial piece of a	around the fuser assembly for
		warm up. Fuser page	page may be torn off in the fuser	any signs of debris or pieces of
		count between 400,000	covering the narrow media sensor.	paper or media.
		and 499,999.	• The narrow media sensor or flag may
			be dislodged or damaged.
202	.44	Exit sensor may have	Exit sensor assembly	Go to “Fuser exit sensor
		bounced. Fuser page		service check” on page 2-92.
		count between 400,000
		and 499,999.
202	.46	Page is covering the exit	Something is keeping the exit sensor in a	Check the fuser and area
		sensor during warm up.	covered position. A page may not have	around the fuser assembly for
		Fuser page count	been cleared from a prior jam.	any signs of debris or pieces of
		between 400,000 and		paper or media.
		499,999.

2-62Service Manual