Interconnect card assembly removal

CAUTION: Unplug the printer before you begin.

Warning: When replacing any one of the following components:

Operator panel assembly (or upper front cover)

System board assembly

Interconnect card assembly

Only replace one component at a time. Replace the required component and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one or the printer will be rendered inoperable.

Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a printer, it can not be used in another printer. It must be returned to the manufacturer.

Warning: Observe all ESD precautions while handling ESD-sensitive parts. See “Handling ESD-sensitive parts” on page 4-1.

Note: Any time the interconnect card assembly is replaced, the Configuration ID must be reset in NVRAM on the new interconnect card. Go to “Configuration ID” on page 3-21.

1.Remove any feature or option cards from the interconnect card.

2.Remove the two screws securing the interconnect card.

3.Remove the interconnect card assembly.

Repair information 4-53

Page 258
Image 258
Toshiba e-STUDIO500P manual Interconnect card assembly removal