Toshiba e-STUDIO500P manual Xx Paper Jam-Check Bin x, Post incomplete, Service Bin

Remove Paper—Output Bin x displays, POST incomplete, unable to clear the message

	FRU	Action
1	Dual output bin sensor flag	Check the flag for correct operation, binding, broken parts, or
		interference from the sensor cable, If incorrect, repair as necessary.
		or replace the output expander option.
271.xx Paper Jam—Check Bin x, POST incomplete

	FRU	Action
1	Pass thru sensor and flag	Check the sensor flag for proper operation. If correct, check to make
	assembly	sure the pass thru sensor cable is correctly connected to J3 on the
	Control board	control board. Disconnect the pass thru sensor cable from J3 on the
		control board and check the voltage at J3-3. The voltage measures
		approximately +5 V dc. If incorrect, replace the control board. If
		correct, check the voltage at J3-2. The voltage measures
		approximately 0 V dc. If incorrect, replace the sensor assembly. If this
		does not fix the problem, replace the output expander option.

271.xx Paper jam - Check Bin x, POST complete, first sheet of paper feeds into output bin x

Note: Before performing the following checks, run the Output Bin X Sensor Test and check for the failing sensor.

Sensor Test:

NF = Near Full (Upper part of sensor assembly)

F = Full (Lower part of sensor assembly)

P = Pass Thru Sensor

990 Service - Bin x

If displayed, replace the output expander option.

No indication that bin x is full or no indication that bin x is near full

	FRU	Action
1	Dual output bin x sensor	Check for correct installation of the sensor cable at J5 on the output
	assembly	expander control board. If either the Bin Full (F) or Bin Near Full (NF)
	Output expander control	fail the sensor test then check the voltage at J5-3 and J5-4. The
	board	voltage measures approximately +5 V dc. If the voltage is incorrect,
		replace the output expander option. If correct, replace the sensor
		assembly.

Diagnostic information 2-111