Output bin sensor standard tray service check

Service tip: If the output bin standard tray fills up and the bin full sensor fails to post the Remove Paper Standard Bin message:

1.Enter the Diagnostics Mode.

2.Select Output Bin Tests.

3.Select Sensor Tests.

4.Select Standard Bin.

5.Check the sensor and flag for proper operation.

If you find no problem with the sensor and flag, continue with the service check.

Service tip: Be sure the flag is correctly installed. The output bin sensor is a normally closed sensor with the sensor flag down. Therefore, unless the flag is in the up position or out of the sensor slot, a Remove Paper Standard Bin message does not display.

 

FRU

Action

 

 

 

1

System board

Check the voltage at J6-1. It measures +5 V dc when the flag is in the

 

Printer fails to display

sensor, and 0 V dc when the flag is out of the sensor. If the voltage

 

does not change, replace the sensor cable assembly. If this does not

 

Remove Paper

 

fix the problem, replace the system board.

 

Standard Bin message.

 

 

 

Output Bin Sensor Test

 

 

fails.

 

 

 

 

2

Output bin sensor flag

Make sure the correct flag is installed. Check the flag for damage or

 

 

improper operation. If incorrect, replace the flag.

 

 

Note: A broken or improper operating sensor flag causes a Remove

 

 

Paper Standard Bin message to display before POST completes

 

 

and cannot be cleared.

 

 

 

Diagnostic information 2-109

Page 145
Image 145
Toshiba e-STUDIO500P manual Output bin sensor standard tray service check, Standard Bin message