Brother BAS-311G Adjusting the thread wiper, Presser foot installation position, Adjustment

7. ADJUSTMENT

7-11. Adjusting the thread wiper

Approx. 2mm

5007Q 5008Q Approx. 3mm 5009Q

1.Loosen the two screws (3) and shift the entire solenoid setting plate (4) up or down to adjust so that the thread wiper (2) is 15 mm in front of the needle center when the plunger (1) of the thread wiper solenoid is driven to the full stroke.

2.Loosen the screw (5) and adjust the position of the thread wiper (2) so that the distance from the thread wiper to the tip of the needle is approximately 2 mm and the tip of the thread wiper (2) is approximately 3 mm from the center of the needle

when the thread wiper (2) passes below the needle during operation. NOTE: Check that the thread wiper (2) does not touch the finger guard.

7-12. Presser foot installation position

Install the presser foot (1) with the screw (2) so that the distance from the bottom of the presser foot to the top of the needle plate is 22 mm when the sewing machine is stopped and the presser foot (1) is raised.

5031Q

BAS-311G, BAS-326G 97