Brother BAS-311G service manual Data editing settings, Device settings

		2. FUNCTION SETTINGS
Data editing settings
No.	Setting	Setting items	Initial value
	range
460	Sewing area	limit in X direction [Units mm]
	0 − 130	BAS-311G setting value	130
	0 − 220	BAS-326G setting value	220
461	Sewing area	limit in Y direction
	0 − 100	[Units mm]	100
	Enlargement/reduction reference point
462	0	Center of sewing frame	0
	1	Sewing start point
	2	Center of pattern
463	Enlargement/reduction for bar tacking		OFF
	OFF	Bar tacking stitches (pitch approx. 1 mm or less) cannot be enlarged or reduced.
	ON	Bar tacking stitches (pitch approx. 1 mm or less) are also enlarged or reduced.
	Enlargement/reduction ratio in XY directions
464	OFF	Disabled	OFF
	ON	Enlargement/reduction ratio setting is the same for X and Y
		(Disabled for user programs)
	Storing parallel	movement amount for sewing pattern
465	OFF	Initialized when program number or enlargement/reduction ratio is changed and	OFF
		when power is turned off.
	ON	Initialized when program number or enlargement/reduction ratio is changed but not
		when power is turned off.
	Reading sewing data from eternal media into internal memory
	0	[Normal mode] Programs are copied one by one into internal memory.
		[Overwrite mode] Sewing data is overwritten into the temporary buffer area.
	1	If sewing data with the same program number already exists in internal memory, it
466		is deleted.	0
		[Assignment mode] Sewing data is overwritten into the temporary buffer area.
		If sewing data with the same program number already exists in internal memory, it
	2	is not deleted, but only the data in the temporary buffer is used.
		(If sewing data with the same program number already exists in internal memory
		and the setting is changed to “0” or “1”, the data in the temporary buffer will be
		cleared.)
	Changing gear	ratio correction method when reading from a 2DD floppy disk.
	0	Automatic conversion as specified by sewing machine model.
467		(For the BAS-311G, data is read as BAS-311A data and then converted.)	0
	1	BAS-311A data is read.
	2	BAS-326A data is read.
	3	BAS-341A/BAS-342A data is read.
468	Retract point	switching at parallel movement point	OFF
	OFF	Disabled
	ON	The position moved to by parallel movement is recorded as the retract point.
Device settings
No.	Setting	Setting items	Initial value
	range
550	Needle cooler	device	OFF
	OFF	Disabled
	ON	Needle cooler device is used. (Option output No. 12)
551	Tension release setting at the sewing start		OFF
	OFF	Disabled
	ON	Enabled
552	Tension release timing during thread trimming [Units 8 degree steps]		0
	-10 − 1	-10: Early ← 0: Standard → 1: Late
553	Thread nipping	timing (*5)	2
	1 − 4	1: Early ← 2: Standard → 4: Late

*5 Not used for the BAS-311G and BAS-326G.

BAS-311G, BAS-326G 11