Brother BAS-311G service manual Function Settings

2. FUNCTION SETTINGS

No.	Setting	Setting items	Initial value
	range
554	Thread breakage detector		OFF
	OFF	Disabled
	ON	Fiber-type thread breakage detector used
555	Thread breakage detector detection sensitivity		OFF
	OFF	5 stitches at sewing start, 3 stitches while sewing
	ON	10 stitches at sewing start, 3 stitches while sewing
	Inner clamping	device (Option output No. 13)
	0	Disabled
		Inner clamping device is used.
556	1	(Retract operation is carried out at the sewing end to prevent interference with the	0
		needle.)
	2	Inner clamping device is used. (No retract operation at the sewing end.)
		Inner clamping device operates for 1/4 of the sewing pattern and returns for the
	3	other 3/4.
		(No retract operation)
	External wiper	device
557	0	Disabled	1
	1	Solenoid-type wiper device is used.
	2	Pneumatic-type wiper device is used. (Option output No. 2)
558	External error	monitoring input	OFF
	OFF	Disabled
	ON	Enabled (P10, option input No. 13 [AIRSW])
	Operating indicator output
559	OFF	Disabled	OFF
		Option output No. 9: Output ON while operating
	ON	Option output No. 10: ON during lower thread conversion and during test mode
		Option output No. 11: ON when error is generated
	Automatic ejector (Option output No. 3 output, option input No. 1 = right sensor, input No. 2 = left
	sensor) [Pneumatic specifications]
560	0	Disabled	0
	1	Standard operation
	2	Sewing starts when cassette sensor is ON
	3	Start switch is enabled even if cassette sensor is OFF.
	Timer from	sensor detection to sewing start when automatic ejector automatic starting is set
561	(memory switch No. 560 = 2) [Pneumatic specifications]		100
	0 − 999	Time from after the cassette is chucked until automatic starting
	Changes the	digital tension setting value.
562	OFF	Tension number can be changed regardless of the sewing data.	ON
	ON	Only tension No. 0 and the tension numbers detected in the sewing data can be
		changed.
563	2-step tension	is possible (When using spring-type main tension)	OFF
	OFF	Disabled
	ON	2-step tension is used.
	Increases maximum tension release force when using a spring-type main tension
	0	Disabled (Tension release is open at the sewing end.)
564	1	Increases the force (Tension release is closed at the sewing end. If tension release	0
		is open, it will be closed in approximately 5 minutes.)
	2	Increases force to the maximum. (Tension release is closed at the sewing end. If
		tension release is open, it will be closed in approximately 1 minute.)
	Thread nipper	device (*6)
565	OFF	Disabled	OFF
	ON	Thread nipper device installed (Memory switch No. 500 must also be set to ON or
		OFF.)
*6 Not used for the BAS-311G and BAS-326G.

12 BAS-311G, BAS-326G