Brother BAS-311G service manual Error processing settings, Maintenance settings

		2. FUNCTION SETTINGS
Error processing settings
No.	Setting	Setting items	Initial value
	range
	Error release	method when operation has stopped
650	0	Press the RESET key.	0
	1	Press the RESET key or the STOP switch.
	2	Press the RESET key or input a signal from the external switch (EXIN3).
	Needle stop	position when sewing is interrupted by the STOP switch
651	0	Needle stops in the down position.	0
	1	Needle stops in the up position.
	2	Needle stops in the up position after thread trimming.
652	Thread trimming operation when sewing is paused		OFF
	OFF	Thread trimming is carried out when the pause is canceled.
	ON	Thread trimming is not carried out when the pause is canceled.
653	Resuming sewing after sewing is paused		OFF
	OFF	STOP switch → RESET key → key → Sewing starts
	ON	STOP switch → RESET key → Sewing starts
655	Disables the	needle up stop position monitoring sensor	OFF
	OFF	Sensor is enabled and needle up stop position errors [E110] are detected.
	ON	Disabled
	Home position	return when sewing is paused
656	OFF	Mechanism moves to home position and then moves to sewing start position.	OFF
	ON	Mechanism steps back to the sewing start position along the sewing path without
		moving to the home position.
Maintenance settings
No.	Setting	Setting items	Initial value
	range
	Run-in operation mode
	0	Disabled
		While the foot switch is being depressed, the work clamp moves up and down
	1	once and then continuous operation starts.
750		(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)	0
		While the foot switch is being depressed, the work clamp moves up and down
	2	twice and then continuous operation starts.
		(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)
		While the foot switch is being depressed, the work clamp moves up and down
	3	three times and then continuous operation starts.
		(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)
751	Run-in operation cycle time adjustment timer		20
	0 − 255	Units [x10 ms]
752	00 − 99	Sewing machine ID code	00
		Sewing data specified on CF card
755	Reading/writing	sewing data for old models	OFF
	OFF	Only compatible with floppy disks.
	ON	Reading and writing using CF cards is possible in data read/write mode.
756	Main shaft angle display mode		OFF
	OFF	Disabled
	ON	Main shaft angle is displayed when sewing machine starts.
Specifications and destination settings
No.	Setting	Setting items	Initial value
	range
	Specification	code setting
	(This memory switch does not return to the initial value when all settings are reset.)
	0	Specifications at the time of shipment from the factory
850		(Specifications shown on the model plate on the machine head)	0
	1	Heavy-weight material specifications
	2	Medium-weight material specifications
	3	Extra heavy-weight material specifications

BAS-311G, BAS-326G 13