Brother BAS-311F-0, BAS-326F-0, BAS-311F-L instruction manual Org

3. INSTALLATION

(10)

(21)

(20)

Lock the cord

clamp at the top.

(13) (12)

1176S

13.Securely connect connectors P1 to P7, P14, P18, P23 and P26 as indicated in table below.

Note

Check that the connector is facing the correct way, and then insert it firmly until it locks into place. Furthermore, lock the cord clamp at the top.

Machine head connectors			Connection location on		Cord clamps used
Connection location	No. of pins	Cord mark	circuit board
X, Y, Sewing sensor	12-pin	[1]	P1	(ORG)	None
Synchronizer	5-pin	[2]	P2	(SYNCHRO)	F
EMERGENCY STOP switch	9-pin	[3]	P3	(HEAD)	None
Solenoid valve	12-pin	[4]	P4	(VALVE)	None
(for pneumatic)
Solenoid					F, G
Presser foot	8-pin	[5]	P5	(SOL)
Thread trimmer
Wiper
Pulse motor, Y	5-pin	[6]	P6 (YPM)		F,G
Pulse motor, X	5-pin	[7]	P7	(XPM)	F, G
	(blue)
Upper shaft motor	3-pin	None	P14 (UVM)		A, B, C, D, E
Operation panel	10-pin	[M]	P18 (PANEL)		A, B
Head position switch	3-pin	[23]	P23 (IMSW)		A, B
Machine specification select	10-pin	[26]	P26 (SELECT)		None
connector

14.Secure the cord bundle (10) with the cord clamp (20).

Note

Check that the cords do not get pulled when the machine head is tilted back gently.

15.Close the cord presser plate (15) in the direction of the black arrow, and secure it by tightening the screws (14).

16.Install the control box cover (main P.C. board mounting plate (13)) with the six screws (12).

Note

Check that the cords do not come into contact with the fan (21) and that they are not clamped by the cover at this time.

BAS-311F-0, 311F-L, 326F-0

13