6. USING THE OPERATION PANEL
6-11. Shifting a stitch pattern
Programs which have already been programmed can be moved up, down and to the left and right. (However, such patterns will be reset if the power supply is turned off or the program number is changed.) 
The feed position can be set to the any position desired.
(5)
(2)(7)
(8)
(10)
(4)
(6)(12) (16) (15)
1226S | 1227S |
1.After the program data has been read, depress the start switch to move the feed mechanism to the sewing start position. If you carry out the following procedure while the program number display (2) is flashing (if the start switch
has not been depressed) 
(The feed position can be set to any position, but it will not be possible to move the stitch pattern.
2.Press the MENU switch (6) until the B.T. COUNTER indicator (10) illuminates.
3.Press and hold the TEST switch (15) and press the R/W switch (4). The test indicator (16) will light, and < 
> will appear in the counter (5).
4.Press the MENU switch (6) so that either the
5.Turn the setting dial (12) to move the feed mechanism one pulse at a time.
If the setting dial is turned counterclockwise while the
If the setting dial is turned clockwise while the
If the setting dial is turned counterclockwise while the
If the setting dial is turned clockwise while the
6.When the TEST switch (15) is pressed after the above fine adjustments have been made, the TEST indicator (16) and display window (5) will both switch off and movement of the stitch pattern will be completed.
Note
When moving the stitch pattern, the sewing start position can be moved to any desired point within the sewing area, but if the pattern goes outside the sewing area, an error will occur during sewing and you will not be able to sew the pattern. Give consideration to the pattern as a whole when moving it.
37
