8. CLEANING AND INSPECTION
8-4. Cleaning the control box air inlet port
(2)
(1)
Use vacuum cleaner to clean the filter in the air inlet port
(2) of the control box (1) at least once a month.
*If the machine is used while the air inlet port is blocked, the inside of the control box will overheat.
When this happens, the overheating error code (“E- d0”) will be displayed and you will not be able to operate the sewing machine.
0126Q
8-5. Cleaning the air holes of belt cover and frame side cover
(1) | (2) |
(3)
1234S
Remove the belt cover (1) and the frame side cover (2), and then clean the air holes (3).
After cleaning, install the belt cover (1) and the frame side cover (2).
*If dust collects in the air holes, it may cause the motor to overheat. The air holes should be cleaned at regular intervals.
In addition, be careful not to let any foreign matter get into the air holes.
8-6. Cleaning the eye guard
1235S
8-7. Checking the needle
Wipe the eye guard clean with a soft cloth.
Note
Do not use solvents such as kerosene thinner to clean the eye guard.
Always check that the tip of the needle is not broken before starting sewing.
1236S
41
