8. CLEANING AND INSPECTION
BAS-311F-0, 311F-L, 326F-0
40
8. CLEANING AND INSPECTION
CAUTION
Turn off the power switch before carrying out cleaning, otherwise the machine may operate if the foot switch is
pressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubric ating oil and grease, so that they do not
get into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vom iting and
diarrhoea. Keep the o il out of the reach of children.
Wait until the motor has cooled down before cleaning the air holes.
The motor may be hot immediately after it has been used, and it may cause burns if touched.

8-1. Cleaning the rotary hook

1. Pull the shuttle hook cover forward to open, and then rem ove the bobbin case.
2. Open the large shuttle hook set claw (1) in the direction indicated by the arrow, and then remove the large shuttle hook
(2) and the inner rotary hook (3).
3. Clean all the dust and thread ends from around the driver (4), the top of the rotar y hook thread gui de and th e shuttle
race.

8-2. Lubrication

Note 1: Fill the machine with oil when the oil level is down to about one-third full in the oil sight glass.
If oil is not added and the oil drops below this level, there is the danger that the machine may seize during
operation.
Note 2: Be sure to let the m achine operate for a while after adding the oil.
Note 3: If there is no more oil on the felt of the shuttle race base, problems with sewing may result, so add oil to the felt
until it is slightly soaked.
Note 4: Use only specified Br other oil (Nisseki Mitsubishi Sewing Lube 10N; VG10) for the machine oil.
Lubrication points refer to “4. LUBRICATION”.

8-3. Draining the oil

1. Remove and empty the waste o il container (1)
whenever it is full.
2. After emptying the waste oil container (1), screw it
back into its original position.
(2) (4)
(3)
(1)
1231S 1232S 1233S
(1)
0125S