Brother FAX 4750 manual DOS Setup Printing Difficulties Paper Handling

DOS Setup

Printing

Difficulties

Paper

Handling

Difficulties

Difficulty	Suggestions
I cannot print from my	Check that the DOS application software
application software.	interface settings match those of your printer:
	for example, if you are using a parallel printer
	cable, you would probably set your DOS
	software printer port to LPT1. Check for an
	error message on the LCD.
The machine prints,	This is an indication that your application
but it prints incorrect	printer emulation Prints setting and the
information.	machine’s printer emulation do not match.
Sometimes	Check your application software to make sure
it prints a couple of	you selected the correct printer driver. The
characters and then	machine emulates HP LaserJet IIP. Try setting
ejects the pages, etc.	the machine to HP emulation in Remote
	Printer Console and then select the
	HP LaserJet IIP printer in your application
	software.
The machine prints the	This is common problem first with database
part of my document	software and part of spreadsheet software when
but does not print the	they are not correctly set up. The data has been
last page (The LCD	sent to the printer but the printer did not receive
shows REMAINED	the Page Eject command. Press FF/Cont to eject
DATA).	the page. Then ask your software supplier how
	to add a Page Eject (or Form Feed) command to
	the end of your print job.
How can I change the	Use the Remote Printer Console (RPC)
user settings or	program.
default settings on the
machine?
The machine does not	Check to see if the CHECK PAPER or
load paper. The LCD	PRINTER JAM message appears on the LCD.
shows CHECK PAPER	If so, the multi-purpose paper cassette may be
or PRINTER JAM.	out of paper or not properly installed. If it is
	empty, load a new stack of paper into the
	feeder. If there is paper in the multi-purpose
	paper cassette, make sure it is straight. If the
	paper is curled, you should straighten it.
	Sometimes it is helpful to remove the paper,
	turn the stack over and put it back into the
	multi-purpose paper cassette. Reduce the
	amount of paper in the multi-purpose paper
	cassette, then try again. Check the manual feed
	mode is not selected in the printer driver.
The machine does not	Reinsert the paper firmly, load one sheet at a
feed paper from the	time. Make sure that manual feed mode is
manual feed slot.	selected in the printer driver.
How can I load	You can load envelopes from the manual feed
envelopes?	slot. Your application software must be set up
	to print the envelope size you are using. This is
	usually done in the Page Setup or Document
	Setup menu of your software. Refer to your
	software application manual.

T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E 17 - 11