Chapter 11

Using a scanned paper document as your watermark

a Press (Copy).

b Enter the number of copies you want.

c Press a or b to choose Watermark Copy. Press OK.

d Press d or c to choose On.

e Press a or b to choose Current Setting. Press OK.

f Press a or bto choose Scan. Press OK, and place the page that you want to use for watermark on the scanner glass.

g Press Black Start or Color Start.

h Take out the watermark document you scanned and load the document you want to copy.

i Press d or c to change the Transparency of the watermark. Press OK.

j If you do not want to change any additional settings, press Black Start or Color Start.

Note

You cannot enlarge or reduce the scanned watermark.

86

Setting your changes as the new default

You can save the copy settings for Quality, Enlarge/Reduce, Brightness, Contrast, Ink Save Mode and

Page Layout that you use most often by setting them as the default settings. These settings will stay until you change them again.

a Press (Copy).

b Press a or b to choose your new setting. Press OK.

Repeat this step for each setting you want to change.

c After changing the last setting, press

aor b to choose Set New Default. Press OK.

d Press 1 to choose Yes. e Press Stop/Exit.

Restoring all settings to the factory settings

You can restore all the settings you have changed back to the factory settings. These settings will stay until you change them again.

a Press (Copy).

b Press a or b to choose Factory Reset. Press OK.

c Press 1 to choose Yes. d Press Stop/Exit.