Brother MFC 7150C owner manual Remote Control Commands

102 C H A P T E R T W E L V E

Remote Control Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (159 ), the system will signal you with two short beeps to enter a remote control command.

Remote Control Commands Details Operation

91Playing voice messages After one long beep, the MFC plays ICMs and Memos.

	1	(Skip back)	Press 1 while listening to an ICM or Memo message to play
			it again. If you press 1 before a message, you will reply the
			previous message.
	2	(Skip next)	While playing an ICM or Memo, you can skip to next
			message.
	9	Stop Playing	Stop playing the ICM and Memo.
92 Record Memo			After one long beep, you can record a memo. You can stop
			recording by pressing 9.

93Erase all ICM & Memo If you hear one long beep, the erase is accepted. If you hear three short beeps, you cannot erase because all voice messages have not been played, or there is no voice message to erase. *This code erases all recorded messages, not one at a time.

94Play and Record OGM in memory

1	Play	1	MSG CTR OGM	The MFC plays the selected OGM. You can stop playing
		2	F/T OGM	OGMs by pressing 9.
2	Record	1	MSG CTR OGM	After one long beep, you can record the selected OGM. Your
				recorded message will be played when you finish speaking.
		2	F/T OGM
				You can stop recording the message by pressing 9.

95Changing Fax Forwarding/ If you hear one long beep, the change is accepted. If you hear

Paging setting		three short beeps, you cannot change it because the conditions
1	OFF	have not been met (Example: registering paging number). You
		can register your fax forwarding number by using 4. FAX
2	Fax Forwarding
		FWD NO (see page 104). Once you have registered the
		number, the MFC will automatically change to
3	Paging
		“FAXFWD:ON” mode. Then retrieve a Memory Status List by
4	FAX FWD NO.	entering 961 (see page 103) to make sure that the Fax
		Forwarding number you registered is correct in the List.

96	Retrieve Fax
	1	Memory Status List	Enter the number of a remote fax machine to receive a report
	2	Retrieve all FAX	or stored fax messages. (See page 103.)
	3	Erase FAX in the	If you hear one long beep, you can erase the fax message
		memory	from the memory.
97	Check the receiving status		You can check whether your MFC has received any FAX or
			VOICE messages. If yes, you will hear one long beep. If no,
	1	FAX
			you will hear three short beeps.
	2	VOICE
98	Change Answer Mode		If you hear one long beep, you can change the answer mode.
	1	MSG CTR	If you hear three short beeps, you cannot change it (For
			example: When there is no MSG CTR OGM and you tried to
	2	FAX/TEL
			change to MSG CTR mode.)
	3	FAX
90	Exit		After a long beep, you can exit remote control.