calibrated. When the screen is touched in a spot and unexpected results occur this is a good indication that the display needs to be calibrated. To calibrate the touch screen select the ‘Calibrate’ button and follow the on screen directions. Try using a stylus of some kind if the problem persists. The eraser end of a pencil or the blunt end of a pen can be used as a good stylus.
2.2.18RESET / REBOOT DISPLAY
► 1234 SETUP
►ADVANCED SETUP
►DISPLAY RESET
Date: 8-4-2010
Revision: 0
Form: 2396
2.2.19OUTDOOR RESET
►
► CONFIGURE
►OUTDOOR RESET
►(page) CENTRAL HEAT
Figure 32 Reset / Reboot Display
The display can be reset or rebooted without powering down the boiler. Select the ‘OK’ button and the display will reboot as shown in paragraph
Figure 33 Outdoor Reset
| When the outdoor | |
| temperature is equal | |
Max outdoor temp | or greater than this | |
value the boiler | ||
(x2) | ||
setpoint will be set to | ||
| ||
| the low water | |
| temperature. | |
| When the outdoor | |
| temperature is equal | |
Min outdoor temp | or less than this value | |
the boiler setpoint will | ||
(x1) | ||
be set to the Central | ||
| ||
| Heat Setpoint value | |
| (y2) see 2.2.21. | |
| This value represents | |
Low water temp | the water temperature | |
setpoint when the | ||
(y2) | maximum outdoor | |
| temperature is | |
| reached. | |
| This value is used to | |
| override the low water | |
Min water temp | temperature of the | |
curve created with the | ||
| ||
| above points without | |
| changing the slope. | |
Max off point | Undefined / Not Used |
Select the ‘Show Line’ button to display a graphical representation for the inputted data
25
