Cabletron Systems 2H28-08R manual Figure C-5 Installing the Fast Ethernet Interface Module

Appendix C: Optional Installations and Mode Switch Bank Settings

3.See Figure C-5. Gently pull the faceplate of the 2H28-08R forward to allow room for the Fast Ethernet Interface Modules to be aligned over the connector.

In the following step, take care when inserting the Fast Ethernet

!Interface Module into the Motherboard connector, so that the

CAUTION	pins do not bend. Otherwise, the Fast Ethernet Interface Board
	and the Motherboard could be damaged.

4.Carefully lower the Fast Ethernet Interface Module onto the standoffs while inserting the module connector into the associated motherboard connector.

Module

Module

Connector

FE-100TX

10 100

Rear

Standoff

Motherboard

Connector

Front

Standoffs

7

8

2251-39

Figure C-5 Installing the Fast Ethernet Interface Module

5.Press down firmly on the Fast Ethernet Interface Module until the pins slide all the way into the motherboard connector. Ensure that the Fast Ethernet Interface Module seats flush on the standoffs.

C-8 2H28-08R SmartSwitch 2208 User’s Guide