
Chapter 3: Installation
Port
SC Connector
Figure 3-6 2H28-08R Fiber Port Connections
4.Verify that a link exists by checking that the port RX LED is on (flashing amber, blinking green, or solid green). If the RX LED is off and the TX LED is not blinking amber, perform the following steps until it is on:
NOTE |
The port RX LED flashes green and amber during bootup.
a.Ensure that the power is turned on for the device at the other end of the link.
b.Verify that the fiber strands between the applicable port on the
c.Make sure that the fiber connection meets dB loss specifications outlined in Section 2.2.
d.To manage the connected port, see Section 5.11.
If a link has not been established, refer to Chapter 4, Troubleshooting, before contacting the Cabletron Systems Global Call Center. Refer to Section 1.6 if the problem has not been resolved.
|