Cabletron Systems 3Com Address Type? range individual, Range of Wireless Clients, 000AF8F00101

Configuring the AP 69

3Verify that values reflect the network environment and change them as needed.

4Do one of the following:

■Select OK to register the settings.

Or:

■Select Save to write changes to NVM, which generates a confirmation prompt.

5Select Save ALL APs [F2] to save the SNMP Configuration information to all APs with the same WLAN Service Area.

This option saves the configuration changes for the current AP, and sends two WNMP messages to all other APs on the Known APs table to update their configurations and reset them after the configuration has been modified. You can execute this option only among the same hardware platforms and same firmware versions.

6Select Cancel [ESC] to disregard any changes made to this screen and return to the previous menu.

Configuring the Access The Access Control List (ACL) supports adding wireless client entries by individual Control List MAC address or by a range of MAC addresses. To select a a method of adding

wireless clients, do the following:

1Select Set Access Control List from the Main Menu. The prompt below displays:

Address Type? range individual

2Press up/down arrows to toggle between range and individual.

Range of Wireless Clients

To select a range of MAC addresses, follow the procedure below.

1Type the minimum MAC address as the top value.

00:0A:F8:F0:01:01

2Press Enter to accept the value.

3Press down arrow to select the maximum value.

4Type the maximum MAC address in the bottom value.

00:0A:F8:F0:02:FF

5Press Enter to accept the value.

6Press down arrow to select OK.

7Press Enter. The UI generates the Ranges of Allowed Mobile Units window.

8Verify that values reflect the network environment and change them as needed.

9Select Delete [F1] to delete a range of Mobile Units.

10Select Add [F2] to add a range of Mobile Units.

11Select Save ALL APs [F3] to save the Ranges of Allowed Mobile Units information to all APs with the same WLAN Service Area. This option saves the configuration changes for the current AP, and sends two WNMP messages to all other APs on the Known APs table to update their configurations and reset them after the configuration has been modified. You can execute this option only among the same hardware platforms and firmware versions.