Sequential Broadcasting

„Sending a Document to More Than One Location

Sequential broadcasting sends one document to more than one location.

You can send to a total of 70 locations as follows:

z One-touch speed dialing

=

9 locations

z Coded speed dialing

=

60 locations

z Regular dialing (Numeric buttons dialing)

=

1 location

You can enter the one-touch speed dialing and coded speed dialing locations in any order. You simply press the one-touch speed dialing button, or press [Coded] or [Directory] followed by the two-digit code.

You can also include one location using regular dialing. Remember that when using regular dialing, you must press [Start/Copy] after entering the number.

Note

zYou must press each button within 10 seconds of the preceding one. The fax begins the operation approximately 10 seconds after you press the last button.

zThe regular dialing number must be entered last.

1Load the document face up into the ADF.

See “Loading Documents and Paper” on page 22.

You can set the scanning resolution and contrast (see page 25).

2Dial the receiving party’s fax numbers as you need.

You can also press [Redial] to redial the last number dialed with the numeric buttons.

TEL= 3456xxxx

3 Press [Start/Copy].

zThe fax reads the document into memory and begins sending.

zTo cancel a transmission, press [Stop/Reset] during dialing or transmission. All transmissions in the sequence are canceled.

32Sending Faxes