„ MEMORY FULL

Cause

Action

The fax’s memory is full because it has

Print and delete any documents stored in memory (see page 39). Then start

received too many documents, or a

again.

very long or detailed document.

 

The fax’s memory is full because you

Free up space in the fax’s memory by printing or deleting any documents in

either tried to send or copy too many

memory you no longer need (see page 39).

pages at once, or you tried to send or

If multiple pages are loaded, separate the pages into smaller stacks. If not, try

copy a very long or detailed document,

sending the document by direct sending (see page 24).

using memory sending.

 

„ NO INK

 

Cause

Action

Ink has run out.

Replace the FINE Cartridge (see page 50).

„ NO TEL #

 

 

 

Cause

Action

The one-touch speed dialing button or

Register the one-touch speed dialing button or coded speed dialing code (see

coded speed dialing code you entered

page 18).

has not been registered.

 

„ REC’D IN MEMORY

 

 

 

Cause

Action

The fax received the document in

Load paper in the Rear Tray (see your setup sheet or page 22), replace the

memory because paper or ink ran out,

FINE Cartridge (see page 50) or clear the paper jam (see page 60).

a paper jam occurred, or the incorrect

Print any documents stored in memory (see page 39).

FINE Cartridge was installed.

 

The fax receives documents in memory

Set the <AUTO PRINT> setting to <ON>. This enables to print received faxes

because the <AUTO PRINT> setting is

automatically (see page 37).

set to <OFF>.

 

„RECOMEND NEW CRT

Cause

Action

Ink is low.

Replace the FINE Cartridge (see page 50).

„REMOVE DOCUMENT

Cause

Action

The document is set while printing.

Remove the document. Press [Stop/Reset] and try printing again.

„SET DOCUMENT IN CORRECT POSITION

Cause

Action

The document cannot be correctly

Make sure the document meets the requirements and is correctly loaded. If

detected or the document is too small.

necessary, reload the document and press [Start/Copy]. See “Document

 

Requirements” on page 20 and “Loading Documents and Paper” on page 22.

„TX/RX CANCELLED

Cause

Action

You pressed [Stop/Reset] to cancel the

If required, try sending again.

transmission.

 

76Troubleshooting