Loading Documents and Paper

1 Open the Document Cover (1) and extend the

(2)

Paper Support (2) to support the paper.

(1)

(1)

(2)

2 Squeeze, then slide the Paper Guide to the left.

3 Insert the stack face up into the Rear Tray (1), and align the right edge of the stack with the right side of the Rear Tray. Then slide the Paper Guide (2) snugly against the left edge of the stack.

z Do not load higher than the paper limit mark ( ).

(2)

(1)

z Be careful not to press the Paper Guide strongly

 

 

 

against the stack, or the paper will not be fed

 

 

properly.

 

 

4 Gently insert the top of the document face up into the ADF until you hear a beep, adjust the Document Guide to the width of the document.

z To avoid feeding problems, make sure the document meets the document requirements (see page 20).

Note

zFor a multipage document, the pages are fed one by one from the top of the stack.

zWait until all pages of your document have been scanned before starting a new job.

zMake sure you follow the procedure to load documents into the ADF. If the document is not loaded into the ADF correctly, it may not be fed into the fax properly; resulting in a jam, or in pages not being sent.

zIf you want to send a document with more than 20 A4- and letter-size (10 legal-size) pages, divide the document into sections and send each section in a separate transmission.

zFor multipage documents, tap the stack on a flat surface to even the edges before loading.

22Before Using Your Machine