TX/RX NO. nnnn
Cause | Action |
When the fax sends or receives a | Write the number down if you will need it later. |
document, it assigns it a unique |
|
identification number (nnnn). |
|
Status Monitor Messages
The following messages are displayed on the status monitor when the machine is performing a function or encounters an error.
Service Error 5100 Is Displayed
Cause | Action |
Movement of the Holder is blocked. | Clear the paper jam or foreign object that is preventing the Holder from moving, |
| then turn off the machine and turn it back on again. |
There may be an obstruction that is not | Check for any obstruction (paper clip, small object, etc.) and also that the |
allowing the Holder mechanism to | protective tape are removed from the FINE Cartridge. Check also for a paper |
move. | jam and clear the jam if necessary (see page 60). Then press [Stop/Reset] and |
| start again. |
The FINE Cartridge may be defective. | Press [Stop/Reset]. Reinstall the FINE Cartridge (see your setup sheet or |
| page 50) and start again. |
| In either case, if the error does not clear, try unplugging the printer. Wait several |
| minutes, then plug it back in. Also, try replacing the FINE Cartridge with a new |
| one (see page 50). |
An error requiring servicing might have | Turn off the machine, and unplug the power cord of the machine from the power |
occurred. | supply. After a while, plug the power cord of the machine back in and turn on the |
| machine. If the same error occurs, contact the service center. |
Service Error B200 Is Displayed
Cause | Action |
An error requiring servicing might have | If using the machine as phone, contact the service center, then turn off the |
occurred. | machine immediately. |
| If not using as phone, turn off the machine immediately, then contact the service |
| center using your phone. |
Service Error nnnn Is Displayed
Cause | Action |
An error requiring servicing might have | Turn off the machine, and unplug the power cord of the machine from the power |
occurred. | supply. After a while, plug the power cord of the machine back in and turn on the |
| machine. If the same error occurs, contact the service center. |
Writing Error / Output Error / Communication Error
Cause | Action |
The machine is not ready. | If [ON] is off, make sure that the power plug is plugged in, then turn the machine |
| on. |
| While [ON] is flashing green, the machine is initializing. Wait until [ON] stops |
| flashing and remains lit green. |
Troubleshooting 77