Redialing When the Line is Busy
There are two methods of redialing: manual redialing and automatic redialing. This section explains these two methods.
Manual Redialing
Press [Redial] to dial the last number you dialed with the numeric buttons*. (This starts redialing regardless of whether automatic redialing is enabled.)
*This setting is only available when you dialed with the numeric buttons.
zCanceling Manual Redialing
To cancel manual redialing, press [Stop/Reset]. You may then need to press [Start/Copy] for a few seconds to feed out the document. See “Jams in the ADF” on page 60.
Automatic Redialing
zWhat is Automatic Redialing?
When you are sending a document and the receiving party’s line is busy, the fax waits the specified time and then dials the same number again. You can set the fax to redial several times if previous attempts fail because of a busy signal.
Automatic redialing can be turned off and on. The number of redialing attempts and the time interval between attempts can also be adjusted (see page 46).
If all redialing attempts are unsuccessful, the fax will cancel the transmission. You can set the fax to print the ERROR TX REPORT to remind you that the transmission was not completed (see page 45).
When automatic redialing is in use, the LCD displays <AUTO REDIAL> while it is waiting to redial.
z Canceling Automatic Redialing
1 Press [Stop/Reset].
Note
If you want to cancel a
zSetting the Options for Automatic Redialing
You can set the following options for automatic redialing:
zWhether or not the fax redials automatically.
zThe number of times the fax attempts to redial.
zThe time interval between redialing attempts.
1 Press [Menu].
2 Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy]. The LCD displays <USER SETTINGS>.
3 Use [{] or [}] to select <TX SETTINGS>, then press [Start/Copy]. The LCD displays <ECM TX>.
Sending Faxes | 29 |