Canon VB150 appendix Static Route Control, Connection Keeping

Static Route Control

Route settings are required when communicating with a wide-area network through a router. When using Ethernet or wireless LAN together with PPP, set the route as needed.

"Default Route"

Specify the route that would normally be used. A gateway address is required if a router on the Ethernet or the wireless LAN side is used.

"Route 1-3"

Use this setting if you require connection routes other than the normal route. You can select from Ethernet, wireless LAN or PPP as the interface. Specify the destination route in the Destination and Mask fields. You must specify a gateway address if you are using a router on an Ethernet or wireless LAN network.

Connection Keeping

When this is selected, an ICMP Echo packet is transmitted periodically to a specified address in order to maintain the network connection.

"Send packet regularly"

Tick this check box to enable this function.

"Target Address"

Specify where the packet should be sent.

"Interval(min.)"

In minutes from 1 to 60, specify the interval at which packet should be sent.

For the packet target address in the connection keeping function, we c recommend that you consider the impact on traffic conditions and set the IP

Note address that is nearest after the auto dial-up router.

Click the [OK] button to change the settings. To discard the changes, click the

[Cancel] button. This returns you to the settings title page.

39