Detail Settings
External Device Common Settings
When using WebView Livescope MV Ver. 2.1 (sold separately → P.16), if these settings are made, all names will be applied to MV. Since these settings are not applied to the viewers (→ P.6), these settings are only required if MV is used.
"External Device Input 1/2"
"External Device Input Name"
Enter on external device input name consisting of up to 15 alphanumeric characters.
"External Device Output 1/2"
"External Device Output Name"
Enter on external device output name consisting of up to 15 alphanumeric characters.
e | Use the Motion Detection Setting Tool (→ P.80) |
for picture recording and external device | |
Tip | control based on motion detection. |
| |
|
|
Picture Recording and output : triggered by external device
Use this setting to operate the picture recording function when recording is performed in conjunction with an external device such as a sensor or switch.
For a detailed example of actual operation, see "dPicture Recording User's Guide" (→ P.1).
"External Device Input 1/2"
Up to 2 recordings from external devices can be set.
"Recording at ON event"
Tick this option to record pictures when an "ON" event is detected from an external device.
"Recording at OFF event"
Tick this option to record pictures when an "OFF" event is detected from an external device.
When you want to record the pictures that proceeds an ON or OFF event, use this setting to enter the required number of seconds.
When you want to record the pictures that follows an ON or OFF event, use this setting to enter the required number of seconds.
"Recording between ON event and OFF event" Tick this option to record pictures for as long as an "ON" status continues from the external device.
"Recording Interval between events" Records pictures at set intervals between ON and OFF event. Specify a value between 1 and 600 seconds as the sampling interval.
"Camera Position"
Selects the camera angle used when pictures are recorded. Select "Not specified", "Home 1" to "Home 4" or "Preset 1" to "Preset 8".
"Send recorded pictures by
You need to make "Mail" settings (→ P.55)
"Output to External Device 1/2"
Tick this check box when you want to control output to an external device. Keep in mind that output to an external device may not always be possible from Admin Viewer or WebView Livescope MV Ver. 2.0/2.1.
"Delay following OFF event (sec.)
When controlling output to an external device and output must retain ON after input is set to OFF, use this setting to specify a delay of up to 20 seconds.
"Set operation time"
When you tick this option, input from an external device is limited to the operation time specified below. Enter the start time and end time for the intervals during which external input is acceptable.
"Handle ON/OFF input in reverse"
On some devices, ON and OFF are reversed. Use this setting for such devices.
3
Detail Settings
48
