Canon VB150 appendix Displaying Motion Detection Status of the Server, Errors

Displaying Motion Detection Status of the Server

The Motion Detection Setting Tool is a PC-based simulation of the motion detection module on the VB150. Depending on the processing capacity of the PC and the network status between the PC and VB150, there may be a divergence between the PC and the actual processing on the VB150. As a result, the motion detection module on the VB150 is enabled and the detection statuses are displayed using icons.

If you select the “Display motion detection status of the server” checkbox, the icons shown below are used to show the status of motion detection.

[Detection disabled]

[Detected]

[Not detected]

c	● The motion detection status of the server display may not match the
	“Motion detected (peak display)” in this tool.
Note	● If the NU-700 is used, setting ND Filter (→ P.97) to ON may cause detection
	errors.
	● When "Display motion detection status of the server" option is selected,
	external device and log output, and picture recording are not performed.

e

Tip

●When the VB150 Motion Detection Function is enabled, the processing load on the VB150 is high. Consequently, the video distribution frame rate may be slower than when the function is disabled. Also, because the video distribution frame rate may be further slowed when the data is sent via a proxy, the use of proxies is not recommended.

●Because the Motion Detection Function detects motion by comparing consecutive image frames, small movements are less likely to be detected when the video quality is poor.

●The motion detection settings should be adjusted and set in conditions that are as close as possible to those for actual operation.

●For detailed information on specifying the settings, see P.5 in the dPicture

Recording User’s Guide.

87