Using the Pattern Sequencer

6. If you want to record notes you play on the

(3)

Checking the timing (beat and measure) of the

keyboard in real time, perform the following

 

playback of other parts, perform keyboard, PITCH

steps.

 

 

BEND (S-1) wheel, and S-2 (MODULATION) button

• The operation you can perform here depends on the

 

operations as required.

 

• The operations you perform are recorded. What

status (page E-103) of the currently selected part, as

 

 

 

you record is played back when recording loops

described below.

 

 

 

 

back to the measure and beat where you recorded

 

 

 

 

For this status:

You can perform this operation:

 

 

a keyboard, pitch bend or modulation operation.

Fix Data

Perform step (2) of the procedure below

 

•

To delete specific recorded notes, hold down the

 

 

C-10 (DELETE) button. When playback reaches

 

to record new notes to replace the

 

 

 

 

 

the note you want to delete, press the keyboard

 

instrument parts in the rec areas.

 

 

 

 

 

that corresponds to the note to be deleted.

 

 

 

 

Recorded Data

Perform step (2) of the procedure below

 

 

 

 

Holding down the C-10 (DELETE) button along

 

to over-record additional notes while

 

 

 

 

 

with one or more keyboard keys while playback is

 

retaining note data previously recorded

 

 

 

 

 

being performed will delete all of the notes that

 

for instrument part.

 

 

 

 

 

correspond to the keyboard keys as they played

 

 

 

 

Empty

Record all new notes (because the rec

 

 

while the button and keys are held down.

 

areas are empty).

 

•

Until you perform step (4) below, you can layer

 

 

 

 

keyboard notes and delete recorded notes as many

 

 

 

 

(1) Press the C-6 (RECORD) button.

 

 

times as you like.

• The button will start to flash and the Digital

(4)

To stop recording, press the C-6 (RECORD) button.

Keyboard will enter record standby.

 

•

This stops accompaniment pattern playback and

 

 

 

 

causes the button to go from lit to unlit. The

 

 

 

 

instrument part status will become “Recorded

 

 

 

 

Data”.

•You can press the C-6 (RECORD) button again here to exit record standby (button goes from lit to unlit).

(2) To start recording while the C-6 (RECORD) button

7. If required, perform the procedure under “To

flashing, press the L-17 (START/STOP) button.

edit events with the pattern sequencer” (page

• This causes the button to change from flashing to

E-115).

lit.

 

• You can make fine corrections to the notes you played

 

on the keyboard and add new notes, if you want. For

 

details, see “Editing Individual Events (Event Editor)”

 

(page E-113).

•If accompaniment pattern playback is stopped, accompaniment pattern repeat playback (excluding the instrument part being recorded) starts. Measure and beat values in the lower right corner of the display will count up along with playback until the end of the accompaniment pattern is reached. Then playback will restart from 001:1.

E-108