Casio CTK-7000, WK-7500, WK7500E1A manual 140

Using a Memory Card

4. Use the R-17 (t, y) buttons to move the 0 to		3. Depending on the type of data you want to save
	“CardFormat”.	to the memory card, perform one of the steps
		shown below.
		• All setup registration banks are saved as a batch. Other
		data is saved in area (data item) units.
		To save this		Do this:
		type of data:
		One user rhythm	1.	Press the L-9 ([F] USER RHYTHMS)
				button.
			2.	Use the dial or R-14(–, +) buttons to
				specify the user rhythm number.
5. Press the R-16 (ENTER) button.
		One user tone	1.	Press the R-11 ([K] USER TONES)
	• This will cause the confirmation message “Sure?” to			button.
			2.	Use the dial or R-14(–, +) buttons to
	appear.
				specify the user tone number.
6. Press the R-14 (YES) button to format the
		One user	1.	Press the R-12 ([L] DRAWBAR ORGAN)
	memory card or the R-14 (NO) button to cancel.	drawbar organ	2.	button.
	• The message “Please Wait” will remain on the display	tone		Use the dial or R-14(–, +) buttons to
				specify the user drawbar organ tone
	while the format operation is being performed. Do not
				number (L:051 through L:100).
	perform any Digital Keyboard operation while this
		One user DSP	1.	Perform steps 1 through 4 under “To use
	message is on the display. “Complete” appears on the
	display after formatting is complete.			a DSP” (page E-32).
			2.	Use the dial or R-14(–, +) buttons to
	• Formatting may take as long as a few minutes to
				specify the user DSP number (101
	complete.
				through 200).
		One user preset	1.	While holding down the L-7 ([D] WORLD/
	Saving Digital Keyboard Data to a
				VARIOUS) button, press the L-8 ([E]
	Memory Card			PIANO RHYTHMS) button to display the
				music preset screen.
	To save Digital Keyboard data to a memory		2.	Press the L-9 ([F] USER RHYTHMS)
				button.
	card		3.	Use the dial or R-14(–, +) buttons to
				specify the user preset number.
1. Insert the memory card into the card slot.
		One song	1.	Press the C-5 (SONG SEQUENCER)
2. If the Digital Keyboard is in the card mode,		sequencer song		button to enter the song sequencer mode.
			2.	Use the dial or R-14(–, +) buttons to
	press the C-9 (CARD) button to exit the card			specify the song number.
	mode.	All registration	Press the C-10 (BANK) button to display the
		banks	registration bank selection screen.

4. While holding down the R-13 (FUNCTION) button, press the C-9 (LOAD/SAVE) button.

• This causes an “Xxxx Load”*1 screen like the one shown below to appear. The sample screen below shows the screen that appears from the rhythm screen.

E-138