Using the Mixer

Mixer Operation

To change mixer parameters

1.Press the C-7 (MIXER) button.

• This causes the mixer screen to appear.

Currently selected setting

(MASTER, DSP, MIC/INST, or A01 to A16/B01 to B16)

Parameter/Setting value

Currently selected setting part (when currently selected setting is A01 to A16/B01 to B16)

2.Use the R-17 (u, i) buttons to select the mixer parameter you want to change.

•You can select master (MASTER), effect (DSP), microphone input (MIC/INST), or a part (A01 through A16, B01 through B16). The currently selected setting is shown in the line two of the display.

•While a part is selected, you can toggle between Group A and Group B by pressing both of the R-17 (u, i) buttons at the same time.

3.Use the R-17 (t, y) buttons to move the thick brackets (%) to the parameter you want to change.

•The parameters that can be configured depend on the currently selected setting. For details, refer to the sections shown in the table below.

When this setting is

These parameters can be

selected:

configured:

MASTER

MASTER parameters

 

(page E-41)

 

 

MIC/INST

MIC/INST parameters

 

(page E-42)

 

 

DSP

DSP parameters (page E-41)

 

 

A01 to A16/B01 to B16

Part parameters (page E-43)

 

 

•When you move the thick brackets (%) to one of the setting values of a part parameter, all of the part parameter values of the Group (A or B) to which the part belongs are indicated by level meter black boxes.

4.Use the dial or R-14 (–, +) buttons to change the setting value.

•Pressing the R-14(–, +) buttons at the same time returns a parameter to its initial default setting.

•You also can change the settings of parameters using the D-1 (PART/COMMON), D-2 (GROUP A/B), and D-3(1-8/9-16)buttons, and sliders D-4 (1/9/EXT) to D-12 (MASTER). For more information, see “Using the Sliders to Change Parameter Settings” (page E-38).

•While the “Part” (part on/off) setting of a part parameter is being configured, pressing both of the R-14(–, +) buttons at the same time will change the setting to “Sol” (Solo). For details, see “Part Parameters” (page E-43).

5.Repeat steps 2 through 4 as required to configure other parameters.

6.To exit the mixer, press the C-7 (MIXER) button or the R-15 (EXIT) button.

•This exits the mixer screen.

•While master (MASTER), effect (DSP) or microphone input (MIC/INST) is selected in step 2 above for setting, you also can perform normal keyboard play (play using layer, split, and Auto Accompaniment).

•While an individual part (A01 through A16, B01 through B16) is selected in step 2 above for setting, pressing a keyboard key will sound only notes of the selected part. All other types of performance operations (layer, split, Auto Accompaniment, etc.) are disabled.

E-37