Using the Mixer

MIC/INST Parameters

MIC/INST parameters include settings related to the T-5 (INST IN) and T-8 (MIC IN) terminals.

Parameter Name

Description

Setting Range

Part

Specifies if sound input should be output (on) or not output (oFF).

oFF, on*

(Mic/Inst Enable)

 

 

 

 

 

Volume

Specifies the volume level of sound input.

0 to 127*

(Mic/Inst Volume)*1

 

 

Pan

Specifies the stereo pan position of sound input. 0 indicates the center, while a

–64 to 0* to +63

(Mic/Inst Pan)

smaller values shifts to the left and a larger value shifts to the right.

 

 

 

 

DSP Line

Specifies whether DSP should be applied to sound input.

oFF, on*

(Mic/Inst DSP Line)

 

 

 

 

 

Rev.Send

Specifies how much reverb is applied to sound input.

0 to 40* to 127

(Mic/Inst Reverb Send)

 

 

 

 

 

Cho.Send

Specifies how much chorus effect is applied to sound input.

0* to 127

(Mic/Inst Chorus Send)

 

 

 

 

 

N.Thresh

Cuts low-volume input sounds, which decreases noise. Allows a signal to pass

0 to 20* to 127

(Mic/Inst Noise Gate

through if it is above the set threshold (gate open). Does not allow a signal to

 

Threshold)*1

pass if it is below the threshold (gate closed).

 

N.Release

Specifies the amount of time for the gate to go from open to fully closed when an

0 to 64* to 127

(Mic/Inst Noise Gate

input sound signal falls below the threshold value specified by “N.Thresh”.

 

Release)*1

Setting 0 will abruptly cut off the sound, while a larger value will cause the gate

 

 

to close more slowly.

 

 

 

 

Auto Level

Automatically controls the input signal level. Selecting “oFF” disables this

oFF*, 1 to 3

(Mic/Inst Auto Level

feature, while a larger value applies a greater degree of control.

 

Control)*1

 

 

*1 See the block diagram under “Configuration of Effects” (page E-29).

E-42