Using the Mixer
Part Parameters
Part parameters include setting items that can be adjusted for parts A01 through A16 and B01 through B16.
Parameter Name | Description | Setting Range |
TONE | Specifies a tone for each part. When configuring this parameter, you can use the | A:001 to L:100 |
(Part Tone) | buttons |
|
| group. |
|
|
|
|
Part | Specifies if the notes of a particular part should be output (on) or not output (oFF). | oFF, on* |
(Part On/Off) | When a part is turned on, the part number is displayed along the bottom of the level |
|
| meter. Part numbers are not displayed for parts that are turned off. |
|
| When playing back a MIDI file or song sequencer song, a “Sol” (Solo) option can be |
|
| specified to play a specific part only. To switch to “Sol”, press both |
|
| buttons at the same time. |
|
|
|
|
Volume | Specifies the volume level of each part. | 0 to 127* |
(Part Volume) |
|
|
|
|
|
Pan | Specifies the stereo pan position of each part. 0 indicates the center, while a smaller | |
(Part Pan) | values shifts to the left and a larger value shifts to the right. |
|
|
|
|
CoarseTune | Specifies, in semitone steps, the pitch of the notes of each part. | |
(Part Coarse Tune) |
|
|
|
|
|
FineTune | Specifies, in cent steps, the pitch of the notes of each part. | |
(Part Fine Tune) |
|
|
|
|
|
BendRange | Specifies the bend range of each part. | 0 to 2* to 24 |
(Part Bend Range) |
|
|
|
|
|
DSP Line | Specifies whether DSP should be applied to each part. Changing this setting from | oFF, on* |
(Part DSP Line) | “oFF” to “on” automatically switches the “Cho/DSP” setting (page |
|
|
|
|
Rev.Send | Specifies how much reverb is applied to each part. | 0 to 40* to 127 |
(Part Reverb Send) | No reverb is applied at all when this setting is 0, while maximum reverb is applied |
|
| when it is 127. |
|
|
|
|
Cho.Send | Specifies how much chorus is applied to each part. | 0* to 127 |
(Part Chorus Send) | No chorus is applied at all when this setting is 0, while maximum chorus is applied |
|
| when it is 127. |
|
|
|
|
Scale | Specifies whether scale (page | oFF*, on |
(Part Scale Enable) | applied (oFF). Equal temperament is applied to parts when this setting is “oFF”. |
|
|
|
|