Reference

DSP Parameter List

Single Type DSP Parameters

01: Wah

This is a “wah” effect that can automatically affect the frequency using an LFO.

Parameters and Value Ranges:

1 :Resonance (0 to 127)

Adjusts the strength of resonance.

2 :Manual (0 to 127)

Adjusts the wah filter reference frequency.

3:LFO Rate (0 to 127) Adjusts the LFO rate.

4:LFO Depth (0 to 127) Adjusts the LFO depth.

5:LFO Waveform (off, sin, tri, random) Selects the LFO waveform.

02: Compressor

Compresses the input signal, which can have the effect of suppressing level variation and make it possible to sustain dampened sounds longer.

Parameters and Value Ranges:

1 :Attack (0 to 127)

Adjusts the attack amount of the input signal. A smaller value causes prompt compressor operation, which suppresses the attack of the input signal. A larger values delays compressor operation, which causes the attack of the input signal to be output as-is.

2 :Release (0 to 127)

Adjusts the time from the point the input signal drops below a certain level until the compression operation is stopped. When an attack feeling is desired (no compression at the onset of sound), set this parameter to as low a value as possible. To have compression applied at all times, set a high value.

3:Level (0 to 127) Adjusts the output level.

4:Threshold (0 to 127)

Adjusts the volume level at which the compression operation starts.

03: Distortion

Digital distortion that applies an overtone to the input signal and distorts it.

Parameters and Value Ranges:

1 :Gain (0 to 127)

Adjusts the input signal gain.

2:Level (0 to 127) Adjusts the output level.

04: Enhancer

Phase shifts low-range sounds and high-range sounds of the input signal to enhance the signal’s profile.

Parameters and Value Ranges:

1 :Low Frequency (0 to 127)

Adjusts the low range enhancer frequency.

2 :Low Phase (0 to 127)

Adjusts the phase shift amount of the low-range enhancer.

3 :High Frequency (0 to 127)

Adjusts the high range enhancer frequency.

4 :High Phase (0 to 127)

Adjusts the phase shift amount of the high-range enhancer.

05: Auto Pan

Performs continual left-right panning of the input signal using an LFO.

Parameters and Value Ranges:

1:LFO Rate (0 to 127) Adjusts the panning rate.

2:LFO Depth (0 to 127) Adjusts the panning depth.

3:LFO Waveform (sin, tri) Selects the LFO waveform.

06: Tremolo

Adjusts the volume of the input signal using an LFO.

Parameters and Value Ranges:

1:LFO Rate (0 to 127) Adjusts the tremolo rate.

2:LFO Depth (0 to 127) Adjusts the tremolo depth.

3:LFO Waveform (sin, tri) Selects the LFO waveform.

07: Phaser

Produces a distinctive pulsating, broad sound by using an LFO to change the phase of the input signal and then mixes it with the original input signal.

Parameters and Value Ranges:

1 :Resonance (0 to 127)

Adjusts the strength of the resonance.

2:LFO Rate (0 to 127) Adjusts the LFO rate.

3:LFO Depth (0 to 127) Adjusts the LFO depth.

4:LFO Waveform (sin, tri, random) Selects the LFO waveform.

E-157