Cisco Systems 1200 manual Attaching the Compliance Label, Access Point Compliance Label Locations

Chapter 5 Upgrading the 5-GHz Radio Module

Installing a 5-GHz Radio Module

Attaching the Compliance Label

There are three places on the 1200 series access point dedicated to compliance labels, one for the product compliance label and two for the radio compliance labels. The label locations are shown in Figure 5-6.

Figure 5-6 Access Point Compliance Label Locations

1

2

3

1

2

		103640
Product compliance label	3	Radio compliance label
Radio compliance label

The product compliance label always occupies the top space (location 1). The two spaces below the product compliance label (locations 2 and 3) contain the radio compliance labels. Whether or not locations 2 or 3 contain labels depends on how your access point is configured. For example, the access point could have two radio compliance labels (one for each radio device installed), or the access point could have only a product compliance label, depending on how it was ordered.

Make sure that your access point has the correct labels after you install or upgrade its radio configuration so that it will be in compliance with regulations in your country.

The AIR-MR21A and AIR RM22A radio upgrade kits ship with the following labels for the 1200 series access points:

•1200 series product compliance label (AIR-AP1210-x-K9)

•1200 series radio compliance label (AIR-RM21A-x-K9 or AIR-RM22A-x-K9)

Table 5-1shows where to place the labels on your 1200 series access point, based on the model you are upgrading. Follow these steps to place the labels correctly:

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-8370-04 5-7