Access Point Specifications

A P P E N D I X C

This appendix provides technical specifications for the 1200 series access point (see Table C-1).

Note The lightweight access points (models: AIR-LAP1231G and AIR-LAP1232AG) do not support the 802.11b radio or the RM20A radio module.

Table C-1	Access Point Specifications

Category		Access Point with 802.11b or 802.11g Radio	Access Point with 802.11a Radio Module

Size		6.56 in. W x 7.23 in. D x 1.66 in. H	With the antenna in the patch position (RM20A or
		16.67 cm W x 18.36 cm D x 4.22 cm H	RM21A):
			6.56 in. W x 8.04 in. D x 2.21 in. H
			16.67 cm W x 20.42 cm D x 5.61 H
			With the RM22A radio module:
			6.56 in. W x 8.76 in. D x 1.66 in. H
			16.67 cm W x 22.25 cm D x 4.22 cm H

Status Indicators		Three indicators on the top panel: Ethernet traffic, status, and radio traffic.

Connectors		Base unit:
		Back panel (left to right): Left RP-TNC antenna connector; power connector (for plug-in AC
		power module); RJ-45 connector for 10BASE-T or 100BASE-T Ethernet connections; upside
		down RJ-45 connector for serial connections; right RP-TNC antenna connector.

Front Panel: Card Bus connector used for an 802.11a radio module.

RM22A radio module:

Left and right RP-TNC antenna connectors

Input Voltage

48 VDC nominal. Operational up to 60 VDC. Voltage higher than 60 VDC can damage the unit.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

	OL-8370-04	C-1

Cisco Systems 1200 manual Access Point Specifications, Access Point with 802.11a Radio Module