Cisco Systems 1200 manual Removing a 5-GHz Radio Module

Chapter 5 Upgrading the 5-GHz Radio Module

Removing a 5-GHz Radio Module

Step 3 Remove the 5-GHz access cover using the supplied Torx L-wrench (see Figure 5-1).

Figure 5-1 5-GHz Radio Access Cover

1 2 1

1

74632

Access Cover Screws 2 Access Cover

Removing a 5-GHz Radio Module

To remove the 5-GHz radio module, follow these steps:

Step 1	Remove all cables and power connections from the access point.
Step 2	Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3	Unscrew the two mounting screws using the supplied Torx L-wrench (Figure 5-2).
	Figure 5-2	5-GHz Radio Module
	1	1	2	3

1

2

74631

Mounting screws 3 Access point

5-GHz radio module antenna

Note Do not attempt to remove the mounting screws from the module; they are captured in the module housing.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-8370-04 5-3