Cisco Systems 1200 manual Attaching the Compliance Labels, Access Point Compliance Labels

Chapter 4 Upgrading the 2.4-GHz Radio

Attaching the Compliance Labels

Attaching the Compliance Labels

There are three places on the 1200 series access point dedicated to compliance labels, one for the product compliance label and two for the radio compliance labels. The label locations are shown in Figure 4-5.

Figure 4-5 Access Point Compliance Labels

1

2

3

1

2

		103640
Product compliance label	3	Radio compliance label
Radio compliance label

The product compliance label always occupies the top space (location 1). The two spaces below (locations 2 and 3) contain the radio compliance labels. Whether or not locations 2 or 3 contain labels depends on how your access point is configured. For example, a dual-band access point could have two radio compliance labels (one for each radio device installed), or it could have only a product compliance label, depending on how it was ordered.

Make sure that your access point has the correct labels after you install or upgrade its radio configuration so that it will be in compliance with regulations in your country.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-8370-04 4-9