Chapter 7 Troubleshooting Lightweight Access Points

Returning the Access Point to Autonomous Mode

Manually Resetting the Access Point to Defaults

You can manually reset your access point to default settings using this EXEC mode CLI command:

Note This command requires the controller configured Enable password to enter the CLI EXEC mode.

clear lwapp private-config

Returning the Access Point to Autonomous Mode

You can return a lightweight access point to autonomous mode by loading a Cisco IOS release that supports autonomous mode (such as Cisco IOS Release 12.3(8)JA or earlier). If the access point is associated to a controller, you can use the controller to load the Cisco IOS release. If the access point is not associated to a controller, you can load the Cisco IOS release using TFTP.

Using a Controller to Return the Access Point to Autonomous Mode

Follow these steps to return a lightweight access point to autonomous mode using a controller:

Step 1 Log into the CLI on the controller to which the access point is associated and enter this command:

config ap tftp-downgradetftp-server-ip-address filename access-point-name (where:

a)tftp-server-ip-addressis the IP address of the TFTP server

b)filename is the full path and filename of the access point image file, such as D:/Images/c1200-k9w7-tar.123-8.JA.tar

c)access-point-nameis the name that identifies the access point on the gondolier.)

Step 2 Wait until the access point completes the reboot, as indicated by the Status LED turning green to indicate a client is associated or blinking green to indicate a client is not associated.

Step 3 After the access point reboots, reconfigure it using the access point GUI or the CLI.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

7-6

OL-8370-04

 

 

Page 84
Image 84
Cisco Systems 1200 manual Returning the Access Point to Autonomous Mode, Manually Resetting the Access Point to Defaults