Cisco Systems 1200 manual Locations for Compliance Labels

Chapter 5 Upgrading the 5-GHz Radio Module

Installing a 5-GHz Radio Module

Step 1 Check the product compliance label to identify the model number of your 1200 series access point. Step 2 Refer to Figure 5-6for the compliance label locations.

Step 3 Use the matrix in Table 5-1to decide which labels to use and where to place them on the access point.

Table 5-1	Locations for Compliance Labels
1200 Series		AIR-RM21A-x-K9 or AIR-RM22A-x-K9	AIR-AP1210-x-K9 Product
Model		Radio Compliance Label	Compliance Label
AIR-AP1220A		Place over existing AIR-RM20A-x-K9	Place over existing product compliance
		radio compliance label or location 3 if no	label.
AIR-AP1230A
		label exists.
All other models			Discard product compliance label.

Step 4 Discard any labels that you did not use.

The 5-GHz radio module installation is now complete and radio settings are at default values. To configure the 5-GHz radio with your wireless network settings refer to the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

5-8 OL-8370-04