9-33
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter9 Configuring IEEE 802 . 1x Port-Based Authentication Configuring IEEE 802.1x Authentication
Setting the Re-Authentication Number
You can also change the number of times that the switch restarts the authentication process before the
port changes to the unauthorized state.
Note You should change the default value of this command only to adjust for unusual circumstances such a s
unreliable links or specific behavioral problems with certain clients an d aut h en ticati on servers .
Beginning in privileged EXEC mode, follow these steps to set the re-authentication number. This
procedure is optional.
To return to the default re-authentication number, use the no dot1x max-reauth-req interface
configuration command.
This example shows how to set 4 as the number of times that the switch restarts the authentication
process before the port changes to the unauthorized state:
Switch(config-if)# dot1x max-reauth-req 4
Configuring IEEE 802.1x Accounting
Enabling AAA system accounting with IEEE 802.1x accounting allows system reload events to be sent
to the accounting RADIUS server for logging. The server can then infer that all active IEEE 802.1x
sessions are closed.
Because RADIUS uses the unreliable UDP transport protocol, account ing messages might be lost due to
poor network conditions. If the switch does not receive the accounting response message from the
RADIUS server after a configurable number of retransmissions of an accounting request, this system
message appears:
Accounting message %s for session %s failed to receive Accounting Response.
When the stop message is not sent successfully, this message appears:
00:09:55: %RADIUS-4-RADIUS_DEAD: RADIUS server 172.20.246.201:1645,1646 is not responding.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify the port to be configured, and enter interface configuration mode.
Step3 dot1x max-reauth-req count Set the number of times that the switch restarts the authentication process
before the port changes to the unauthorized state. The range is 0 to 1 0; the
default is 2.
Step4 end Return to privileged EXEC mode.
Step5 show dot1x interface interface-id Verify your entries.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.