39-17
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter39 Configuring IPv6 Unicast Routing Configuring IPv6
Configuring IPv6 ICMP Rate Limiting
IPv6 ICMP rate limiting uses a token-bucket algorithm for limiting the rate at which IPv6 ICMP error
messages are sent to the network. The interval between error messages is specified in a time interval and
a bucket size. Because some applications, such as traceroute, sometimes require replies to a group of
requests to be sent out in rapid succession, specifying only the interval betw een error messages can cause
the application to fail. The token bucket allows a number of token s, each repre senting the abilit y to send
one error message, to be stored in virtual buckets. For every message to be se nt, one to ken is re moved
from the bucket. If a series of error messages is generated, error messages can be sent until the bucket is
empty. When the bucket is empty, IPv6 ICMP error messages are not sent until a new token is placed in
the bucket. This method does not increase the average rate-limiting time interval, but it provides more
flexibility than fixed-time intervals.
ICMP rate limiting is enabled by default with a default interval between error messages of 100
milliseconds and a bucket size (maximum number of tokens to be stored in a bucket) of 10.
Beginning in privileged EXEC mode, follow these steps to change the ICMP rate-limiting parameters:
To return to the default configuration, use the no ipv6 icmp error-interval global configuration
command.
This example shows how to configure an IPv6 ICMP error message interval of 50 milliseconds and a
bucket size of 20 tokens.
Switch(config)#ipv6 icmp error-interval 50 20
Configuring CEF and dCEF for IPv6
Cisco Express Forwarding (CEF) is a Layer 3 IP switching technology us ed t o optim ize net work
performance. CEF implements an advanced IP look-up and forwarding algorithm to deliver maximum
Layer 3 switching performance. It is less CPU-intensive than fast-switching route-caching, allowing
more CPU processing power to be dedicated to packet forwarding. In a switch stac k, the hardware uses
distributed CEF (dCEF) in the stack. IPv4 CEF and dCEF are enabled by default. IPv6 CEF a nd dCEF
are disabled by default, but automatically enabled when you c on figure I Pv6 ro uti ng.
To route IPv6 unicast packets, you must first globally configure forwarding of IPv6 unicast packets by
using the ipv6 unicast-routing global configuration command, and you must configure an IPv6 address
and IPv6 processing on an interface by using the ipv6 address interface configuration command.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 ipv6 icmp error-interval interval [bucketsize] Configure the interval and bucket size for IPv6 ICMP error
messages:
•interval—The interval (in milliseconds) between tokens
being added to the bucket. The range is from 0 to
2147483647 milliseconds.
•bucketsize—(Optional) The maximum number of tokens
stored in the bucket. The range is from 1 to 200.
Step3 end Return to privileged EXEC mode.
Step4 show ipv6 interface [interface-id] Verify your entries.
Step5 copy running-config startup-config (Optional) Save your entries in the configuration file.