16-4
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter16 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Configuring IEEE 802.1Q Tunneling
Configuring IEEE 802.1Q Tunneling
These sections contain this configuration information:
•Default IEEE 802.1Q Tunneling Configuration, page 16-4
•IEEE 802.1Q Tunneling Configuration Guidelines, page 16-4
•IEEE 802.1Q Tunneling and Other Features, page 16-6
•Configuring an IEEE 802.1Q Tunneling Port, page 16-6

Default IEEE 802.1Q Tunneling Configuration

By default, IEEE 802.1Q tunneling is disabled because the default sw itch por t mo de i s dynam ic auto .
Tagging of IEEE 802.1Q native VLAN packets on all IEEE 802.1Q trunk ports is also disable d.

IEEE 802.1Q Tunneling Configuration Guidelines

When you configure IEEE 802.1Q tunneling, you should always use an asymm etr ica l l ink b etw een the
customer device and the edge switch, with the customer de vice po rt con figur ed as a n IEEE 80 2.1Q tr unk
port and the edge switch port configured as a tunnel port.
Assign tunnel ports only to VLANs that are used for tunneli ng .
Configuration requirements for native VLANs and for and maximum transmission units (MTUs) are
explained in these next sections.

Native VLANs

When configuring IEEE 802.1Q tunneling on an edge switch, you must use IEEE 802.1Q trunk ports for
sending packets into the service-provider network. However, packets going through the core of the
service-provider network can be carried through IEEE 802.1Q trunks, ISL trunk s, or nontrunking links.
When IEEE 802.1Q trunks are used in these core switches, the n ative VLANs of the IEEE 802.1Q trunks
must not match any native VLAN of the nontrunking (tunneling) port on the same switch because traffic
on the native VLAN would not be tagged on the IEEE 802.1Q sending trunk port.
See Figure 16-3. VLAN 40 is configured as the native VLAN for the IEEE 802. 1Q tru nk por t f rom
Customer X at the ingress edge switch in the service-provider network (Switch B). Switch A of
Customer X sends a tagged packet on VLAN 30 to the ingress tunnel port of Switch B in the
service-provider network, which belongs to access VLAN 40. Because the access VLAN of the tunnel
port (VLAN 40) is the same as the native VLAN of the edge-switch trunk port (VLAN 40), the metro
tag is not added to tagged packets received from the tunnel port . Th e p ac ket ca rri es o nl y th e VL AN 30
tag through the service-provider network to the trunk port of the egress-edge switch (Switch C) and is
misdirected through the egress switch tunnel port to Customer Y.