12-12
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter12 Configuring VLANs
Configuring Extended-Range VLANs
To return an interface to its default configuration, use the default interface interface-id interface
configuration command.
This example shows how to configure a port as an access port in VLAN 2:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 2
Switch(config-if)# end
Configuring Extended-Range VLANs
When the switch is in VTP transparent mode (VTP disabled), you can create extended- range VLANs (i n
the range 1006 to 4094). Extended-range VLANs enable service providers to extend t he ir in frastr uctu re
to a greater number of customers. The extended-range VLAN IDs are allowed for any switchport
commands that allow VLAN IDs. You always use config-vlan mode (accessed by entering the vlan
vlan-id global configuration command) to configure extended-range VLANs . The extended range is not
supported in VLAN database configuration mode (accessed by entering the vlan database privileged
EXEC command).
Extended-range VLAN configurations are not stored in the VLAN database, but because VTP mode is
transparent, they are stored in the switch running configuration file, and you can save the configuration
in the startup configuration file by using the copy running-config startup-config privileged EXEC
command.
Note Although the switch supports 4094 VLAN IDs, see the “Supported VLANs” section on page 12-2 for
the actual number of VLANs supported.
These sections contain extended-range VLAN configuration info rma ti on:
•Default VLAN Configuration, page 12-12
•Extended-Range VLAN Configuration Guidelines, page 12-13
•Creating an Extended-Range VLAN, page12-14
•Creating an Extended-Range VLAN with an Internal VLAN ID, page12-15

Default VLAN Configuration

See Table12-2 on page 12-8 for the default configuration for Ethernet VLANs. You can change only the
MTU size, private VLAN, and the remote SPAN configuration state on extended-range VLANs; all other
characteristics must remain at the default state.
Step7 show interfaces interface-id switchport Verify your entries in the Administrative Mode and the Access Mode
VLAN fields of the display.
Step8 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose