35-8
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter35 Configuring IPv6 ACLs
Configuring IPv6 ACLs
Use the no {deny | permit} IPv6 access-list configuration commands with keywords to remove the deny
or permit conditions from the specified access list.
This example configures the IPv6 access list named CISCO. The first deny entry in the list denies all
packets that have a destination TCP port number greater than 5000. The second deny entry denies
packets that have a source UDP port number less than 5000. The second deny also logs all matches to
the console. The first permit entry in the list permits all ICMP packets. The second permit entry in the
list permits all other traffic. The second permit entry is necessary because an implicit deny -all condition
is at the end of each IPv6 access list.
Switch(config)# ipv6 access-list CISCO
Switch(config-ipv6-acl)# deny tcp any any gt 5000
Switch config-ipv6-acl)# deny ::/0 lt 5000 ::/0 log
Switch(config-ipv6-acl)# permit icmp any any
Switch(config-ipv6-acl)# permit any any
Applying an IPv6 ACL to an Interface
This section describes how to apply IPv6 ACLs to network interfaces. If the switch is running the
advanced IP services feature set, you can apply an ACL to outbound or inbo und tra ffic on Laye r 3
interfaces, or to inbound traffic on Layer 2 interfaces. If the switch is running the IP services or IP base
feature set, you can apply ACLs only to inbound management traffic on Layer 3 interfaces.
Beginning in privileged EXEC mode, follow these steps to control access to an interface:
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Identify a Layer 2 interface (for port ACLs) or Layer 3 interface (for rou ter
ACLs) on which to apply an access list, and enter interface conf iguration m ode.
Note Switches running the IP services or IP base feature set do not suppo rt
port ACLs.
Step3 no switchport If applying a router ACL, change the interface from Layer 2 mode (the default)
to Layer 3 mode.
Step4 ipv6 address ipv6-address Configure an IPv6 address on a Layer 3 interface (for router ACLs).
Note This command is not required on Layer 2 interfaces or if the interface
has already been configured with an explicit IPv6 address.
Step5 ipv6 traffic-filter access-list-name
{in | out}Apply the access list to incoming or outgoing traffic on the interface.
Note The out keyword is not supported for Layer 2 interfaces (port ACLs).
If the switch is running the IP services or IP base feature set, the out
keyword is not supported for Layer 3 interfaces.
Step6 end Return to privileged EXEC mode.
Step7 show running-config Verify the access list configuration.
Step8 copy running-config
startup-config (Optional) Save your entries in the configuration file.