23-28
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter23 Configuring IGMP Snooping and MVR
Configuring IGMP Filtering and Thrott li ng
To remove the maximum group limitation and return to the default of no maximum, use the no ip igmp
max-groups interface configuration command.
This example shows how to limit to 25 the number of IGMP groups that a port can join.
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp max-groups 25
Switch(config-if)# end
Configuring the IGMP Throttling Action
After you set the maximum number of IGMP groups that a Layer 2 interface can join, you can configure
an interface to replace the existing group with the new group for which the IGMP report was received
by using the ip igmp max-groups action replace interface configuration command. Use the no form of
this command to return to the default, which is to drop the IGMP join report.
Follow these guidelines when configuring the IGMP throttling action:
•This restriction can be applied only to Layer 2 ports. You can use this command on a logical
EtherChannel interface but cannot use it on ports that belong to a n Ethe rC hanne l po rt g roup.
•When the maximum group limitation is set to the default (no maximum), entering the ip igmp
max-groups action {deny | replace} command has no effect.
•If you configure the throttling action and set the maximum group limitation after an interface has
added multicast entries to the forwarding table, the forwarding-table entries are either aged out or
removed, depending on the throttling action.
–
If you configure the throttling action as deny, the en tries t hat were pre v iously i n the f orwa rding
table are not removed but are aged out. After these entries are aged out and the maximum
number of entries is in the forwarding table, the switch drops the n ext IGMP report received on
the interface.
–
If you configure the throttling action as replace, the entries that were previously in the
forwarding table are removed. When the maximum number of entries is in the forwar ding table,
the switch replaces a randomly selected entry with the received IGMP report.
To prevent the switch from removing the forwarding-table entries, you can configure the IG MP
throttling action before an interface adds entries to the forwarding table.
Beginning in privileged EXEC mode, follow these steps to configure the throttling action when the
maximum number of entries is in the forwarding table:
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify the physical interface to be configured, and enter interface
configuration mode. The interface can be a Layer 2 port that does not
belong to an EtherChannel group or an EtherChannel in ter face. The
interface cannot be a trunk port.
Step3 ip igmp max-groups action {deny |
replace}When an interface receives an IGMP report and the maximum number
of entries is in the forwarding table, specify the action that the interface
takes:
•deny—Drop the report.
•replace—Replace the existing group with the new group for which
the IGMP report was received.