41-10
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter41 Configuring Cisco IOS IP SLAs Operations
Configuring IP SLAs Operations
Step3 udp-jitter {destination-ip-address
| destination-hostname}
destination-port [source-ip
{ip-address | hostname}]
[source-port port-number]
[control {enable | disable}]
[num-packets number-of-packets]
[interval interpacket-interval]
Configure the IP SLAs operation as a UDP jitter operation, and enter UDP
jitter configuration mode.
•destination-ip-address | destination-hostname—Specify the destination IP
address or hostname.
•destination-port—Specify the destination port number in the range from 1
to 65535.
•(Optional) source-ip {ip-address | hostname}—Specify the source IP
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination
•(Optional) source-port port-number—Specify the source port number in
the range from 1 to 65535. When a port number is not specified, IP SLA s
chooses an available port.
•(Optional) control—Enable or disable sending of IP SLAs control
messages to the IP SLAs responder. By default, IP SLAs control messages
are sent to the destination device to establish a connection with the IP
SLAs responder
•(Optional) num-packets number-of-packets—Enter the number of
packets to be generated. The range is 1 to 6000; the default is 10.
•(Optional) interval inter-packet-interval—Enter the interval between
sending packets in milliseconds. The range is 1 to 6000; the default value
is 20 ms.
Step4 frequency seconds (Optional) Set the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 secon ds.
Step5 exit Exit UDP jitter configuration mode, and return to global configuratio n m ode.
Step6 ip sla monitor schedule
operation-number [life {forever |
seconds}] [start-time {hh:mm [:ss]
[month day | day month] | pending
| now | after hh:mm:ss] [ageout
seconds] [recurring]
Configure the scheduling parameters for an individual IP SLAs operation.
•operation-number—Enter the RTR entry number.
•(Optional) life—Set the operation to run indefinitely (forever) or for a
specific number of seconds. The range is from 0 to 2147483647. The
default is 3600 seconds (1 hour).
•(Optional) start-time—Enter the time for the operation to begin collecting
information:
–
To start at a specific time, enter the hour, minute, second (in 24-hour
notation), and day of the month. If no month is entered, the default is
the current month.
–
Enter pending to select no information collection until a start time is
selected.
–
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to show that the operation should start after the
entered time has elapsed.
•(Optional) ageout seconds—Enter the number of seconds to keep the
operation in memory when it is not actively collecting information. The
range is 0 to 2073600 seconds, the default is 0 seconds (never ages ou t).
•(Optional) recurring—Set the operation to automatically run every day.
Command Purpose