17-2
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter17 Configuring STP
Understanding Spanning-Tree Features
•Supported Spanning-Tree Instances, page 17-10
•Spanning-Tree Interoperability and Backward Compatibility, page17-11
•STP and IEEE 802.1Q Trunks, page 17-11
•VLAN-Bridge Spanning Tree, page 17-11
•Spanning Tree and Switch Stacks, page 17-12
For configuration information, see the “Configuring Spanning-Tree Features” section on page 17-1 2.
For information about optional spanning-tree features, see Chapter 19, “Configuring Optional
Spanning-Tree Features.”
STP Overview
STP is a Layer 2 link management protocol that provides path redundancy while preventing loops in the
network. For a Layer 2 Ethernet network to function properly, only one active path can exist between
any two stations. Multiple active paths among end stations cause loops in the network. If a loop exists
in the network, end stations might receive duplicate messages. Switches might also learn end-station
MAC addresses on multiple Layer 2 interfaces. These conditions result in an unstable network.
Spanning-tree operation is transparent to end stations, which cannot det ect whe the r th ey are c onn ect ed
to a single LAN segment or a switched LAN of multiple segments.
The STP uses a spanning-tree algorithm to select one switch of a redundantly connected ne twork as the
root of the spanning tree. The algorithm calculates the best loop-free path through a swi tched La yer 2
network by assigning a role to each port based on the role of the por t in th e ac tive topolo gy:
•Root—A forwarding port elected for the spanning-tree topology
•Designated—A forwarding port elected for every switched LAN segment
•Alternate—A blocked port providing an alternate path to the root bridge in the spanning tree
•Backup—A blocked port in a loopback configuration
The switch that has all of its ports as the designated role or as the backup role is the root switc h. Th e
switch that has at least one of its ports in the designated role is called the designated switch.
Spanning tree forces redundant data paths into a standby (blocked) state. If a network segment in the
spanning tree fails and a redundant path exists, the spanning-t ree al gorithm r eca lcu lat es t he
spanning-tree topology and activates the standby path. Switches send and receive spanning-tree frames,
called bridge protocol data units (BPDUs), at regular intervals. The switches do not forward these frames
but use them to construct a loop-free path. BPDUs contain information about the sending switch and its
ports, including switch and MAC addresses, switch priority, port priority, and path cost. Spanning tree
uses this information to elect the root switch and root port for the switched network and the root port and
designated port for each switched segment.
When two ports on a switch are part of a loop, the spanning-tre e por t pr iori ty an d pat h cost se tt ings
control which port is put in the forwarding state and which is put in the blocking state. The spanning-tree
port priority value represents the location of a port in the network topology and ho w well it is located to
pass traffic. The path cost value represents the media speed.
Note By default, the switch sends keepalive messages (to ensure the connection is up) only on interfaces that
do not have small form-factor pluggable (SFP) modules. You can change the default for an interface by
entering the [no] keepalive interface configuration command with no keywords.