1-12
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter1 Overview
Features
Layer 3 Features
These are the Layer 3 features:
Note Some features noted in this section are available only in the IP services feature set.
•HSRP for Layer 3 router redundancy
•IP routing protocols for load balancing and for constructing scalable, routed backbones:
–
RIP Versions 1 and 2
–
OSPF (requires the IP services feature set)
–
Enhanced IGRP (EIGRP) (requires the IP services feature set)
–
Border Gateway Protocol (BGP) Version 4 (requires the IP services feature set)
•IP routing between VLANs (inter-VLAN routing) for full Layer3 routing between two or more
VLANs, allowing each VLAN to maintain its own autonomous data-link domain
•Policy-based routing (PBR) for configuring defined policies for traffic flows
•Multiple VPN routing/forwarding (multi-VRF) instances in customer edge devices to allow service
providers to support multiple virtual private networks (VPNs) and overlap IP addresses between
VPNs (requires the IP services feature set)
•VRF Lite for configuring multiple private routing domains for network virtualization and virtual
private multicast networks
•Support for these IP services, making them VRF aware so that they can operate on multiple routing
instances: HSRP, uRPF, ARP, SNMP, IP SLA, TFTP, FTP, syslog, traceroute, and ping
•Fallback bridging for forwarding non-IP traffic between two or more VLAN s (re qu ire s the I P
services feature set)
•Static IP routing for manually building a routing table of network path information
•Equal-cost routing for load-balancing and redundancy
•Internet Control Message Protocol (ICMP) and ICMP Router Discovery Protocol (IRDP) for using
router advertisement and router solicitation messages to discover the addr esses of routers on directly
attached subnets
•Protocol-Independent Multicast (PIM) for multicast routing within the network, allowing for
devices in the network to receive the multicast feed requested and for switches not participating in
the multicast to be pruned. Includes support for PIM sparse mode ( PIM -SM), PIM de nse m ode
(PIM-DM), and PIM sparse-dense mode (requires the IP services feature set)
•Multicast Source Discovery Protocol (MSDP) for connecting multiple PIM-SM domains (requires
the IP services feature set)
•Distance Vector Multicast Routing Protocol (DVMRP) tunneling for interconnecting two
multicast-enabled networks across nonmulticast networks (requires the IP services feature set)
•DHCP relay for forwarding UDP broadcasts, including IP address requests, from DHCP clients
•IPv6 unicast routing capability for forwarding IPv6 traffic through configured interfaces (requires
the advanced IP services feature set)
•Support for EIGRP IPv6, which utilizes IPv6 transport, communicates with IPv6 peers, and
advertises IPv6 routes
•IP unicast reverse path forwarding (unicast RPF) for confirming source packet IP addresses.