Wireless (for ISA550W and ISA570W only)
Configuring the Basic Settings
Cisco ISA500 Series Integrated Security Appliances Administration Guide 208
5
Viewing Wireless Client Status
Use the Client Status page to view information for all client stations that are
already connected to each SSID. The MAC address and IP address for all
connected client stations for each SSID are displayed. To open this page, click
Wireless > Wireless Status > Client Status. This page is automatically updated
every 10 seconds. Click Refresh to manually refresh the data.
Configuring the Basic SettingsUse the Basic Settings page to change the wireless mode to suit the devices in
your network, specify the wireless channel and bandwidth for operation to resolve
issues with interference from other access points in the area, or enable U-APSD
and SSID Isolation if needed.
STEP 1 Click Wireless > B asic Settings.
STEP 2 Enter the following information:
•Wireless Radio: Click On to turn wireless radio on and hence enable the
SSID called “cisco-data,” or click Off to turn wireless radi o off. Enabling any
SSID will turn on wireless radio. Disabling all SSIDs will turn off wireless
radio.
•Wireless Mode: Choose the 802.11 modulation technique.
-802.11b/g mixed: Choose this mode if some devices in the wireless
network use 802.11b and others use 802.11g. Both 802.11b and 802.11g
clients can connect to the access point.
-802.11b/g/n mixed: Choose this mode to allow 802.11b, 802.11g, and
802.11n clients operating in the 2.4 GHz frequency to connect to the
access point.
-802.11n only: Choose this mode if all devices in the wireless network
can support 802.11n. Only 802.11n clients operating in the 2.4 GHz
frequency can connect to the access point.
•Wireless Channel: Choose a channel from a list of channels or choose Auto
to let the system determine the optimal channel to use based on the
environmental noise levels for the available channels.