Configuration Wizards
Using the DMZ Wizard to Configure DMZ Settings
Cisco ISA500 Series Integrated Security Appliances Administration Guide 72
2
STEP 5 Enter the following information:
•Service: Choose either DynDNS or No-IP service.
NOTE: You must sign up for an account with either one of these providers
before you can use this service.
•Active On Startup: Click On to activate the DDNS setting when the security
appliance starts up.
•WAN Interface: Choose the WAN port for the DDNS service. Traffic for
DDNS services will pass through the specified WAN port.
NOTE: If the WAN redundancy is set as the Failover mode, this option is
grayed out. When WAN failover occurs, DDNS will switch traffic to the active
WAN p or t.
•User Name: Enter the username of the account that you registered in the
DDNS provider.
•Password: Enter the password of the account that you registered in the
DDNS provider.
•Host and Domain Name: Specify the complete host name and domain
name for the DDNS service.
•Use wildcards: Check this box to allow all sub-domains of your DDNS host
name to share the same public IP address as the host name.
•Update every week: Check th is box to update the host information e very
week.
STEP 6 Click OK to save your settings.
STEP 7 After you are finished, click Next.
Configuring DMZ NetworkSTEP 8 Use the DMZ Configuration page to configure the DMZ networks.
NOTE: Up to 4 DMZ networks can be configured on the security appliance. You
must configure at least one DMZ network to finish the DMZ wizard.
STEP 9 Click Add to create a DMZ network .
Other options: To edit an entry, click the Edit (pencil) icon. To delete an entry, click
the Delete (x) icon.